RHINO RC456 Manual do Operador descarregar pdf (Página 16)

CONNECTING THE RAKE TO THE TRACTOR

With the rake supported by the wheel teeth and the stand, back the tractor to the rake and connect the tractor to the

3-point linkage. After connecting to the tractor raise the machine and remove the stand from the 3-point linkage.

Raise the rake guard using the tractor hydraulics until the teeth are off of the ground. Slide the Lock Plate (27) to the

rear "B" to allow the rake to "float" during operation. (See Illustration 7). This will allow the rake to adapt to

irregular ground and reduce wheel damage.

IMPORTANT: The lock plate must be in the forward position "A" whenever the rake is being transported or not in

operation.

By using adjustment holes 1 through 6 in the right or left positions minor adjustments can be made when raking,

spreading and turning the crop. When transporting the rake, the stop pin must be installed in position 7.

(See Illustration 9).

Illustration 9

Illustration 7

OPERATION

The 3-Point Pin (10) is used to adjust the operating position of the rake. Position "A" (See Illustration 8) is used for

raking position to the right. Position "B" is used for raking to the left.

Illustration 8

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Sem comentários

RHINO RC456 Manual do Operador Página 16